Many Thanks,
brett

Can you tell me why you have the REACT.ini set up to look for everything at ”c:changer”. I take it this is where I have to install EAC (instead of Exact Audio Copy) and MediaChanger? Or can I just change the REACT.ini? Did you do this to remove spaces in names and paths?

thanks!

b

Thank you very much for getting back to me. Please excuse me and my questions for I feel like I am on some sort of Digital Archaeologists journey here, digging back through time but not in a linear fashion.

I did previously download your mods to REACT2, but have been confused by so many posts in so many forums…for example (and as brief as possible):

1) Can you verify the installation instructions for your mod of react? Are they the same as those mentioned here: http://www.hydrogenaudio.org/forums/index.php?showtopic=35158

2) This post says REACT will not work with EAC .99 and gives no instructions for installing 2.0: http://www.hydrogenaudio.org/forums/index.php?showtopic=50259

3) In your mod, is there a reason why the ”REACT.au3”, ”REACT.ico” and make.bat are under the main dir?

4) I am assuming that if I install your version of REACT2.0 correctly I will be in good shape…I understand enough (to test at least) the REACT.ini and .cfg’’s but to tell you the truth I have no idea how to initiate the batch rip. Do I need autoit or is there a .bat I need to create and run…?

Again, thank you very much for getting back to me. I really appreciate it.

Best,
Brett

Questions are as follows:
1) Installed as a part of REACT 2.0 are the following files: ”react.cmd”, ”make.bat”, ”play.au3” and ”REACT.au3”. I have attempted to use autoit to run the .au3′’s, but with no luck and the .bat and .cmd files open dos shells full of errors (later if you”d like I can send them).
2) Do I need to use MediaChanger to mount a disc before I begin?
3) What am I missing here to begin the automated ripping? If I use autoItv3 to execute the ”REACT.au3” EAC comes up but that’’s it?
4) REACT 2.0 has no instructions for install, I fear my mistake may be here….? Right now all directories are separate and under c:changer and the paths inside the REACT.ini have been changed to reflect the current path to MediaChanger.exe
c:changer>REACT2>REACT.exe
c:changer>EAC>EAC.exe
c:changer>GUI-055>temp>MediaChanger.exe
5) Can you suggest ‘’stable versions” of the software you used? There have been many changes I fear since you did what you did.

Once again…any help would be greatly appreciated.

Thanks,
Brett

brettra2@yahoo.com

Again I apologize for the intrusion

I am new to this and have no scripting/programing knowledge (although I can get around in Linux and have written a .bat script here and there for MentalRay renders). I have attempted to use the GUI created by MediaDogg (avsforum) and have attempted to contact him with questions/problems I am having. At this point I have had no success, so I figured I”d go back to the source.

…however in looking at your orginal post here I still have no idea how to get REACT to work with the ”raw” MediaChanger files (as downloaded from above).

It seems given my lack of ability/experience that I may be too much of a ”hard-case” to receive assistance, but assistance of any kind would be greatly appreciated.

Many Thanks,
Brett

brettra2@yahoo.com

Mass duplication (original material) might pay for the changer.